Sunday, May 19, 2013

incoming fax not working elastix 2.4 - Elastix Forums :: Open Source ...

Thank You for your help. Since 1.3 did work very well I did wanted to go thru the pain. I changed to 2.4 because I needed to see what was new and practice going thru the suffering. 2.0 is working great and it has over 60 trunks and over 100 etx. It is too much work to upgrade it.

When a fax call in it ring twice and goes to busy signal.

I am using ZAP Trunk compatibility with DAHDI and directing the DID to the each FXO port.

My dahdi-channels.conf is: (I am using Loopstart since the lines do not work with KS)

signalling=fxs_ls
callerid=asreceived
group=0
context=from-zaptel
channel => 1
callerid=
group=
context=default

;;; line="2 WCTDM/4/1 FXSKS"
signalling=fxs_ls
callerid=asreceived
group=1
context=from-zaptel
channel => 2
callerid=
group=
context=default

;;; line="3 WCTDM/4/2 FXSKS"
signalling=fxs_ls
callerid=asreceived
group=2
context=from-zaptel
channel => 3
callerid=
group=
context=default

1. I had already eliminated the echo cancelatation.

2. my system.conf is:
# Span 1: WCTDM/4 "Wildcard TDM400P REV I Board 5" (MASTER)
fxsls=1
echocanceller=none,1
fxsls=2
echocanceller=none,2
fxsls=3
echocanceller=none,3
# channel 4, WCTDM/4/3, no module.

# Global data

loadzone = us
defaultzone = us
echocanceller=none,4

3. And my dahdi.conf

# options wctdm24xxp latency=6

loadzone = us
defaultzone = us

Source: http://www.elastix.org/index.php/en/component/kunena/38-hylafax/122041-incoming-fax-not-working-elastix-24.html

eastbay Samantha Steele Dec 21 2012 doomsday Is The World Going To End Mayans camilla belle

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.